What you'll need
Ethernet or Wi-Fi network connection
Minimum internet connection of 3 Mb/s upload and download per device
Any custom network settings (check with your IT Manager)
You can learn more about network requirements here.
🏁 Getting started
Unpack the device
Remove the device from the box
Take out the two foam pieces inside the device
Connect to power
Plug in the supplied power cable to the device
If using Ethernet, connect the device to your network using the supplied Ethernet cable
Check the indicator lights for device's status:
| Device is initializing. |
| Device is connected and ready to start a job at discovery.reshapebiotech.com |
| Internet connection needs to be configured. |
Steady white
Blinking yellow
🌐 Configuring internet connection
If your robot can’t connect to the internet, it will enter Internet Configuration Mode, indicated by a blinking yellow light. In this mode, the robot creates a WiFi network. Connect to it to set up the internet settings.
Connect your phone or computer to your device's WiFi network
Your device's WiFi and password can be found on the label on the right side of the device
Once connected, go to http://10.42.0.1/ to open the online setup guide.
Click Setup robot and follow instructions on the screen to configure your network settings.